If they bled good and the pedal still goes to the floor you need to check the brake master.
2000 saab breaks going to floor but breaks.
But as i continue to drive and use the brake the pressure increases until it s entirely hard.
60000 mi us 275.
Repeat the process described above and pay attention to the fluid flowing the clear plastic tube.
Initially you will see small air bubbles in the line.
I have a 2000 saab 9 3 convertible.
I can still brake but all travel has disappeared and you have to apply a bit more force for the brake to.
6mm hex wrench 4.
The pedal went right to the floor.
As brake fluid flows through the clear plastic tube the assistant will notice the brake pedal falling towards the floor.
However brakes still lock up seize drag while driving.
There s some travel before the car starts braking.
Dealer replaced hydraulic unit master cylinder problem still exists.
Close the bleeder valve before the pedal reaches the floor.
T30 torx socket 3.
Reported to saab customer service no response.
However based on past complaints that i have seen on this web site i feel that it is time to address this issue before someone gets injured.
3 8 or 10mm 17mm 19mm or e 20 torx for 2002 and newer 9 5 s 2.
New brake pads 2.
Gm says all 6 cyl saabs 207 and newer will have this hose fail.
Bad brake vac hose going to vac pump.
When the car starts the brake pressure feels normal.
The clutch and everything has maybe 10 miles on it.
Torque wrench for parts you will need.
Replaced the master cylinder as the old one was difficult to push in actuate during bench bleeding and wouldn t retract easily.
On 7 4 09 and 7 6 09 started car and backed out of garage and had no brakes.
Maybe something was not put back together right.
Took over 3 weeks to find a new one 300 mi away.
I do not go into replacing the emergency brake system as my shoes were not worn out.
2000 saab 9 3 brakes are dragging after vehicle warms up.
Started the car today and went to press in the clutch and there was no resistance.
Braking reduced by 40 percent.
Brakes seemed to work fine after that.
2005 saab 9 3 arc convertible.
Used e brake to prevent car from going into street.
Straight edge screwdriver 7.
For tools you will need.
Spongy brakes pedal goes almost to floor.
I am thinking that it is in the slave cylinder.
